Bridgeport H320 Horizontal Machining Center 2018 – 2 Pallets bearbetningscenter

Hardinge H320 – a 2018 horizontal machining center built for unattended running
This Hardinge H320 is a compact horizontal machining center from 2018, controlled by a Siemens Sinumerik 828D. It was specified for shops that want parts coming off the machine while the operator is already loading the next job.
The two-pallet system is the point
While one pallet is being machined, the other is loaded outside the working area. Setup time disappears into cycle time instead of sitting next to it. On repeat work in batches, that difference is measured in hours per shift, not minutes.
A spindle that suits real work
The 18,000 rpm HSK-A63 spindle with 23 kW of drive power and 20 bar through-spindle coolant is a genuinely high-speed configuration for a machine of this footprint. It cuts aluminium at the speeds high-speed programming assumes, and has the torque and rigidity for steel when the job calls for it. The HSK-A63 interface holds accuracy far better than a taper connection at these speeds, and tooling for it is available from every supplier.
Accuracy you can prove
Direct scales on X, Y and Z mean position is measured at the axis, not inferred from the ballscrew. Thermal growth and screw wear do not quietly walk your dimensions out of tolerance over an eight-hour run. The 360° direct-drive rotary table indexes to any angle, so four faces of a part are machined in one clamping — with the fixture errors that come from re-clamping simply removed.
Everything specified for lights-out operation
40-tool magazine with separate-door changer — reload tooling without opening the machine
Automatic door and 3-colour stack light — robot- and monitoring-ready
Scraper chip conveyor and full base and ceiling wash-down — chips leave the machine on their own
Automatic grease lubrication — no daily manual routine to forget
Condition and availability
The machine is located in The Netherlands and is available immediately. A 2018 HMC in this configuration typically has years of productive life ahead of it, and current lead times on a comparable new machine run to many months. You are welcome to inspect it under power by appointment and run your own test part.
Interested?
Send us your part drawing or the material and batch size you have in mind, and we will tell you within one working day whether the H320 is the right fit — including honestly if it is not.

Make / model Hardinge
H320
Control Siemens Sinumerik 828D
X-axis travel 460 mm
Y-axis travel 460 mm
Z-axis travel 410 mm
B-axis 360° (direct drive table
max. 200 rpm)
Rapid traverse X/Y/Z 48 m/min
Pallet size 320 × 320 mm
Max. workpiece diameter 320 mm
Max. workpiece height 320 mm
Pallet load 250 kg
Number of pallets 2
Spindle taper HSK-A63
built-in BBT
Max. spindle speed 18,000 rpm
Spindle motor power 23 kW
Spindle cooling 20 bar through-spindle coolant
Tool magazine 40 positions
separate-door tool changer
Measuring system Direct scales on X
Y and Z
Chip removal Scraper chip conveyor
Coolant / wash Base wash
ceiling wash-down
manual wash gun
Lubrication Automatic grease lubrication
Other Automatic door
3-colour stack light
Power supply 400 V / 50 Hz
CE marked
Dimensions (L × W × H) 3,550 × 1,950 × 2,602 mm
Country of manufacture Taiwan
Location The Netherlands
Availability Immediately